2 connecting cable – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 96

12.2 Connecting cable
Please use only HEIDENHAIN connecting cables.
HEIDENHAIN recommends that a 37-pin D-subminiature connector should be mounted on the
machine operating panel. The machine operating panel can be connected to the logic unit with the
standard HEIDENHAIN connecting cable Id.-Nr. 263 954 ..
max. 40 m
Id.-Nr. 263 954 ..
If the machine operating panel does not have a 37-pin D-subminiature connector, the HEIDENHAIN
connecting cable Id.-Nr. 244 005 .. may be used.
max. 40 m
Id.-Nr. 244 005 ..
For the assignments of the multi-core conductors see "PLC inputs/outputs".
If for any reason the manufacturers of the machine have to produce their own cable, a 37-pin
connector is available from HEIDENHAIN (Id.-Nr. 243 937 ZY).
This manual is related to the following products: