HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 427)

01.98
TNC 407/TNC 415/TNC 425 3 List of machine parameters 5-25
3.7 Integral PLC
Machine
parameter Function and input Change
via Reaction Page
MP4010 PLC-program from RAM or from EPROM
Entry: 0 or 1
0 = EPROM-operation
1 = RAM-operation
RESET 7-28
MP4060.0-4 Path dependent lubrication
Entry: 0 to 65 535
[units of 65 536 µm] PLC RUN 4-19
MP 4070 Compensation value per PLC cycle for axis error
compensation with lag tracking
Entry: 0.0001 to 0.005 [mm] 4-32
MP4110.0
to
MP4110.47 Value for Timer T0 to T47
Entry: 0 to 65 535 [PLC-cycles]
(TNC 415: 20 ms; TNC 407: 24 ms) PLC RUN 7-25
MP4120.0
to
MP4120. 31 Pre-set value for counters C0 to C31
Entry: 0 to 65 535 [PLC cycles] PLC RUN 7-26
MP4130 Fast PLC input to suppress the monitoring
functions
Entry: 0 to 255 [No. of the PLC input] PLC EDIT 4-83
MP4131 Activation condition for fast PLC input from
MP4130
Entry: 0 or 1 PLC EDIT 4-83
MP4210.0
to
MP4210.47 Set a number in the PLC (D768 to D956)
Entry: –99 999.9999 to +99 999.9999 [mm] or [°] PLC EDIT 7-21
MP4220.0-4 Machine parameter with multiple function
Entry: 10 to 30 000
–
Feed rate for returning to the contour
– To set a number in the PLC in the word range
W960 to W968
PLC EDIT
4-148
7-23
MP4230.0
to
MP4230.31 Set a number in the PLC (Module 9032)
Entry: –99 999.9999 to +99 999.9999 7-23
MP4231.0
to
MP4231.31 Set a number in the PLC (Module 9032)
Entry: –99 999.9999 to +99 999.9999 7-23
MP4310.0-6 Set a number in the PLC ( W976 to W988)
Entry: 0 to 65 535 PLC EDIT 7-22
7-178
MP4410 Activation of analogue inputs
Entry: %xx
Bit 0 = 0 no analogue inputs on 1st extension
1 analogue input on 1st extension
Bit 1 = 0 no analogue inputs on 2nd extension
1 analogue input on 2nd extension
PLC RUN 4-206