HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 704)

01.98
TNC 407/TNC 415/TNC 425 2 Dialogs for OEM-cycles 9-7
2 Dialogs for OEM-cycles
The dialog numbers defined in the dialog blocks of the OEM-cycles determine the text to be
displayed from the dialog file concerned. Which dialog file is active will depend on the dialog
language selected (MP7230) and whether dialogs are read from the EPROM or are stored in the NC
program memory (see the section on "Functions for file management" in the "PLC Programming"
Manual).
The dialog numbers (input: 0 to 127) of the dialog block are assigned to the first 128 lines of a dialog
file.
Example:
DLG-DEF 0/1/.../127
Dialog number in OEM-cycle Line number of dialog file Dialog example
0 1 BOLT HOLE CIRCLE
1 2 NUMBER OF HOLES
. . .
. . .
. . .
127 128 PITCH
Up to 20 characters can be displayed on a dialog line. In all, a maximum of 34 characters may be
input, being reproduced in full in the NC program, but only in abbreviated form on the dialog line.