beautypg.com

HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual

Page 322

background image


01.98

TNC 407/TNC 415/TNC 425

10 Electronic handwheel

4-197

MP7640 Handwheel

Entry: 0 to 6

0 = no handwheel
1 = HR 330 (all keys evaluated by NC)
2 = HR 130 or HR 330
3 = HR 330 (+, - and "rapid traverse" keys evaluated by PLC)
4 = HR 332 (all keys evaluated by PLC)
5 = up to three HR 150 via HRA 110
6 = HR 410

MP7641

Entry of interpolation factor
Entry: 0 or 1
0 = entry at TNC control panel
1 = entry via PLC module 9036

MP7645

Initializing parameters for handwheel
Entry: 0 to 255

MP7645.0 to MP7645.7 currently evaluated only by HR 332, HR 410 or HRA 110 (see following
description).

MP7650

Count direction for handwheel
Entry: 0 or 1
0 = negative count direction
1 = positive count direction

MP7660

Threshold sensitivity for electronic handwheel
Entry range: 0 to 65 535 [increments]

MP7670

Interpolation factor for handwheel
Entry range: 0 to 10

MP7670.0

Interpolation factor for low speed

MP7670.1

Interpolation factor for medium speed (HR 410 only)

MP7670.2

Interpolation factor for high speed (HR 410 only)

Marker

Function

Set

Reset

M2826

Suppress handwheel pulses

PLC

PLC