HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 156)

01.98
TNC 407/TNC 415/TNC 425 1 Machine axes 4-31
Input and output of the correction tables via the data interface
The .CMA and .COM files can be uploaded and downloaded via the data interface in the "PLC
Programming" mode. The .CMA file is assigned the extension .S and the .COM file the extension .V.
An axis of rotation is a special case
With an axis of rotation, the system only recognizes corrections of entries from 0 to 360.
Correction table with code number 105 296
In the interest of compatibility we have retained the entry of correction tables with code number 105
296. This was the only possible way of entering the correction tables up to software issue 250 94X
07 (243 03X 07).
The following constraints apply:
Only one dependency per axis can be programmed
Max. correction difference =
Comp. point spacing
64
Always 64 compensation points per axis
If no .CMA file has been defined and non-linear axis error compensation is selected with MP730,
then the correction tables from code number 105 296 apply.
MP730 Selection of linear or non-linear axis error compensation
Entry: %xxxxx
Bit 0 X axis 0 = Linear axis error compensation
Bit 1 Y axis 1 = Non-linear axis error compensation
Bit 2 Z axis
Bit 3 4th axis
Bit 4 5th axis