beautypg.com

2 axes in position, And m2017 are set (see section "axis in position") – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual

Page 215

background image


4-90

TNC 407/TNC 415/TNC 425

3 Servo positioning of the NC-axes

01.98

Marker

Function

Set

Reset

M2451

Feed rate enable for all axes

PLC

PLC

M2467

Complement feed rate enable

Address

Function

B520

Axis-specific feed rate enable

Bit 0

+1

Feed rate enable Axis X

+0

No Feed rate enable Axis X

Bit 1

+2

Feed rate enable Axis Y

+0

No Feed rate enable Axis Y

Bit 2

+4

Feed rate enable Axis Z

+0

No Feed rate enable Axis Z

Bit 3

+8

Feed rate enable 4th axis

+0

No Feed rate enable 4th axis

Bit 4

+16

Feed rate enable 5th axis

+0

No Feed rate enable 5th axis

3.6.2 Axes in position

If the axes have reached the defined positioning window (MP1030, see section "Positioning
window") after a movement, the "axis in position" markers are set by the NC. This also happens
after switching on the control voltage.

As soon as a positioning is started, the markers are reset by the NC. This is also valid when passing
over the reference marks. In the "Electronic handwheel" mode of operation the markers M2008 to
M2011 and M2017 are reset.

For contours which can be machined with constant feed rate the "Axis in position" markers are not
set.

Marker

Function

Set

Reset

M2008

X axis in position

NC

NC

M2009

Y axis in position

M2010

Z axis in position

M2011

4th axis in position

M2017

5th axis in position