beautypg.com

HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual

Page 679

background image


8-32

TNC 407/TNC 415/TNC 425

2 TNC data interfaces

01.98

Output selected file

The TNC outputs all of the program lines in order. The peripheral unit can stop transmission with
character and start it again with character .

Peripheral unit

Transmission path

. . .
1st line of file

TNC

.
.

.

.
.

.

Last line of file

.
.

.

6th line of file

5th line of file

Output all files

The procedure is similar to the protocol described in paragraph 3.1.2 "Outputting a selected file". The
TNC arranges all the programs in order and transmits them. No control character is sent between
the individual files.

Output file with acknowledgement

The programs are transmitted in the same way as described in section 3.1.3 "Outputting all files".
However, an acknowledgement is expected from the user between the transmission of individual
programs.

Read-in selected file

If a file is read in from a peripheral unit (e.g. a PC), the corresponding name must be indicated in the
TNC and the TNC be started first, i.e. the TNC outputs the character . Transmission of the file
concerned is then initiated at the peripheral unit.
When the entire file has been transferred, the TNC sends character .