2 pocket milling – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 270

MP7245.1
Inhibit the HEIDENHAIN standard-Cycles 16 to 30
Entry:
0 to 65 535
$0 to $FFFF
Bit 0
Cycle 16
0 = do not disable
Bit 1
Cycle 17
1 = disable
Bit 2
Cycle 18
Bit 3
Cycle 19
Bit 4
Cycle 20
Bit 5
Cycle 21
Bit 6
Cycle 22
Bit 7
Cycle 23
Bit 8
Cycle 24
Bit 9
Cycle 25
Bit 10
Cycle 26
Bit 11
Cycle 27
Bit 12
Cycle 28
Bit 13
Cycle 29
Bit 14
Cycle 30
Bit 15
Cycle 31
6.7.2 Pocket milling
The overlap-factor for clearing out a rectangular or circular pocket (Cycle 4 and Cycle 5) can be
altered by machine parameters.
Stepover
Stepover = (MP7430) x cutter radius
MP7430
Overlap-factor for pocket milling
Entry: 0.100 to 1.414
This manual is related to the following products: