HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 205)

4-80
TNC 407/TNC 415/TNC 425 3 Servo positioning of the NC-axes 01.98
3.4 Contour behaviour
3.4.1 Radial acceleration
As well as the normal acceleration (MP1060) there is also a machine parameter for radial
acceleration (MP1070).
The machine parameter limits the feed for circular movements according to the following formula:
v = r [m] · MP1070 [m/s 2 ] v= feed rate for circular movements [m/s]
r= radius [m] (cutter mid-point contour)
It is recommended that a value should be entered which is between the half of and the same as that
in MP1060 (Acceleration). If the programmed feed is lower than that above, then the programmed
feed will be used. MP1070 is effective for operation with lag and with feedforward control.
MP1070 Radial acceleration
Entry: 0.001 to 5.000 [m/s
2 ]
3.4.2 Constant feed rate in corners
Machine parameter MP7460 defines the angle which can still be traversed with constant surface
speed. This machine parameter is effective for corners without a radius compensation, for internal
corners it is also effective with a radius compensation.
MP7460
This machine parameter is effective for operation with feedforward control as well as for operation
with lag. The permissible size of the angle depends on the drives in the machine.
Realistic values are 5° to 15°.