HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 438)

5-36
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
Machine
parameter Function and input Change
via Reaction Page
MP7250 Difference between Q-parameter numbers for
DLG-CALL-block and DLG-DEF-block in OEM cycle
Entry: 0 to 50 PLC RUN 9-5
MP7251 Number of global Q parameters transferred from
OEM cycle to calling program
Entry: 0 to 100 PLC RUN 9-5
MP7260 Number of tools in the tool table
Entry: 0 to 254 CN 123 RESET 4-225
MP7261 Number of pockets in tool carousel
Entry: 0 to 254 CN 123 RESET 4-225
MP7264 Number of reserved pockets for special tools
Entry: 0 to 3 RESET 4-226
MP7266 Items in tool table
Entry: 0 to 99
0 = No display
1 to 99 = Position in tool table
MP7266.0 Tool name (NAME)
MP7266.1 Tool length (L)
MP7266.2 Tool radius (R)
MP7266.3 Tool radius 2 (R2)
MP7266.4 Oversize tool length (DL)
MP7266.5 Oversize tool radius (DR)
MP7266.6 Oversize tool radius 2 (DR2)
MP7266.7 Tool locked? (TL)
MP7266.8 Replacement tool (RT)
MP7266.9 TIME 1
MP7266.10 TIME 2
MP7266.11 CURRENT TIME
MP7266.12 Commentary on the tool (DOC)
MP7266.13 No. of tool cutting edges (CUT)
MP7266.14 Wear tolerance for tool length
(LTOL)
MP7266.15 Wear tolerance for tool radius
(RTOL)
MP7266.16 Cutting direction of the tool
(DIRECT)
MP7266.17 PLC status (PLC)
MP7266.18 Tool length offset (TT:L-OFFS)
MP7266.19 Tool radius offset (TT:R-OFFS)
MP7266.20 Breakage tolerance for tool
length (LBREAK)
MP7266.21 Breakage tolerance for tool
radius (RBREAK)
CN 123 4-225