HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 159)

4-34
TNC 407/TNC 415/TNC 425 1 Machine axes 01.98
MP1512 Limit of extent of stiction compensation
Entry: 0 to 16 777 215 (counting steps)
MP1512.0 X axis
MP1512.1 Y axis
MP1512.2 Z axis
MP1512.3 4th axis
MP1512.4 5th axis
MP1513 Feed-rate limit for stiction compensation
Entry: 0 to 300 000 (mm/min)
MP1513.0 X axis
MP1513.1 Y axis
MP1513.2 Z axis
MP1513.3 4th axis
MP1513.4 5th axis
MP1391 Feed precontrol in all operating modes
Entry:
%xxxxx
Bit 0 X axis 0 = Feed precontrol in the ”Positioning with MDI”,
Bit 1 Y axis ”Program run, single block”, and ”Program run, full
Bit 2 Z axis sequence” operating modes
Bit 3 4th axis 1 = Feed precontrol in all operating modes
Bit 4 5th axis