HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 32)

3-2
TNC 407/TNC 415/TNC 425 01.98
8 Touch probe system input 3-36
8.1 Connector assignment X12 3-36
8.2 Connection of the touch probe system 3-37
8.2.1 TS 120 3-37
8.2.2 TS 511 3-38
8.2.3 TM 110 3-39
9 Data interface 3-40
9.1 RS-232-C/V.24 data interface 3-40
9.2 RS-422/V.11 data interface 3-41
10 Handwheel input 3-43
10.1 Pin assignment 3-43
10.2 Portable handwheel HR 330 3-43
10.3 Integral handwheel HR 130 3-44
10.4 Portable handwheels with permissive buttons 3-45
10.5 Handwheel adapter HRA 110 3-49
11 PLC inputs/outputs 3-51
11.1 Technical data 3-52
11.1.1 PLC inputs 3-52
11.1.2 PLC outputs 3-52
11.1.3 Analog inputs 3-53
11.1.4 Inputs for Pt 100 thermistors 3-53
11.2 Connector assignment 3-54
11.2.1 PLC inputs 3-54
11.2.2 PLC outputs 3-55
11.2.3 PL connection 3-55
11.3 Connector assignment on the PL 3-56
11.3.1 Connection to LE or PL #1 3-56
11.3.2 Connection of PL #2 3-56
11.3.3 PLC inputs/outputs on the PL 400 3-57
11.3.4 PLC inputs/outputs on the PL 410 / PL 410 B 3-59
11.3.5 Analog inputs on the PL 410 / PL 410 B 3-60
11.3.6 Inputs for thermistors on the PL 410 / PL 410 B 3-60
11.4 Connector assignment on the PA 110 3-61
11.5 Connecting cable 3-61
11.5.1 Connection of PLC inputs/outputs on the LE 3-61
11.5.2 PL 400 connection 3-62
11.5.3 PL 410 / PL 410 B connection 3-62
11.5.4 PA 110 connection 3-62
11.5.5 Connection to analog inputs 3-63
11.5.6 Connection to inputs for thermistors 3-63