Plc positioning module, Introduction, 1 plc positioning module 1.1 introduction – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 710

TNC 407/TNC 415/TNC 425
1 PLC positioning module
1 PLC positioning module
1.1 Introduction
One hardware version of the LE 360 - the LE 234.003 - can be used in conjunction with the
TNC407/TNC415 as a positioning module.
This means that the TNC 407/TNC 415 can be extended by up to 4 secondary axes. PLC inputs and
outputs of the LE 234.003 can also be used.
The positioning module can be used for toolchangers, for pallet infeed and for controlling rotary axes
and swivel heads.
The NC software of the TNC 360 can also run on the LE 234.003, i.e. all functions of the TNC 360
are also available with the positioning module.
Detailed technical particulars are given in "Technical Manual TNC 360"
This manual is related to the following products: