HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 29
2-25
TNC 415 B/TNC 425:
280 54x 05
TNC 415 F/TNC 425 E:
280 56x 05
TNC 407:
280 58x 05
Release 3/96
Improvements:
−
The Polish dialog language was added, Id. Nr. 280 590 xx, 280 550 xx and 280 570 xx.
−
Contour Pocket cycle (cycle 6, 15, 16, 21, 22, 23, 24)
MP7420
Bit 4 = 0:
After the contour pocket is machined, the TNC moves to the position that was
last approached before the cycle was called.
Bit 4 = 1:
After the contour pocket is machined, the TNC moves the tool to clearance height.
−
Module 9036 Limiting jog increment
Transferred value:
0 to 50 mm = Limiting jog increment
–1; <–2 or >50 =
Jog increment limit is canceled and the last increment entered is
activated.
–2 =
Jog increment limit is canceled and the minimum from the last
increment entered and the last limiting value is activated.
TNC 415 B/TNC 425:
280 54x 06
TNC 415 F/TNC 425 E:
280 56x 06
TNC 407:
280 58x 06
Release 5/96
Improvements:
−
MP1925 Limit for integral factor of the speed controller new.