3 software types 259 93, 259 94 and 243 03 – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 22
3.5.3 Software types 259 93, 259 94 and 243 03
TNC 415 B/TNC 425:
259 93x 04
TNC 415 F/TNC 425 E:
259 94x 04
Release 11/92
New functions:
−
New functions for programmed contour approach and withdraw
−
"Working Plane" cycle for machines with swivel head
−
"Contour Train" cycle
−
"Scaling factor axis-specific" cycle
−
Three-dimensional tool compensation in DNC mode
−
Extended tool management
−
Extended additional status displays for file information, positions, tool data and coordinate
transformation
−
Stiction compensation
−
PLC axes
−
Extended PLC command set
−
Length of filenames increased to 16 characters
−
Automatic correction of centre offset for probe system
−
Oscilloscope function
−
New organization for PLC files
−
Additional machine parameters for data transfer to PLC
−
BACKUP and RESTORE functions
−
Q parameter for tool length (Q114)
−
Axis positions after programmed probe cycle in Q parameters Q115 to Q119
−
New input format for machine parameters
TNC 415 B/TNC 415:
259 93x 05
TNC 415 F/TNC 425 E:
259 94x 05
Release 11/93
New functions:
−
−
The minimum input range of machine parameters MP6120, MP6350, MP6360 has been changed
from 80 mm/min to 10 mm/min.
−
MP7300 has been extended as follows:
MP7300
Delete status display, Q parameter and tool data
Entry: 0 to 7
0 = delete status display, Q parameter and tool data when selecting a program
1 = delete status display, Q parameter and tool data with M02, M30, END PGM
and selecting a program
2 = delete status display and tool data when selecting a program
3 = delete status display and tool data with M02, M30, END PGM and selecting a
program
4 = delete status display and Q parameter when selecting a program
5 = delete status display and Q parameter with M02, M30, END PGM and
selecting a program
6 = delete status display when selecting a program
7 = delete status display with M02, M30, END PGM and selecting a program