3 software, Option, 3 software option – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 12

New functions will be introduced only in the following software types:
TNC 415B / TNC 425:
280 54
TNC 415F / TNC 425 E:
280 56
TNC 407:
280 58
These software types are therefore supplied as standard.
3.1.3 Software option
HEIDENHAIN offers the "Digitising with TS 120" function as a software option (see chapter "Machine
integration"). An additional software protection module is installed in controls supplied with this
software option. The Id.-Nr. of the logic unit indicates another version. If the software module is
installed, the option is indicated on the screen under the NC and PLC software numbers.
Logic units that have already been delivered can be retrofitted with the software protection module.
Please contact HEIDENHAIN if you wish to buy this option for your existing control. The proper
component model must be ordered for a specific hardware model.
Digitizing with TS 120:
Id.-Nr. of the installation kit
Id.-Nr. of software module
NC software
TNC 407
265 313 01
243 02, 243 03, 280 58
TNC 415A
265 314 01
246 051 01
259 96
TNC 415B
TNC 425
286 405 01
280 54
Digitizing with TM 110:
Id.-Nr. of the installation kit
Id.-Nr. of software module
NC software
TNC 415B
TNC 425
286 405 02
246 051 03
280 54