HEIDENHAIN ND 261 v.2 - Manual

Working with the measured
value display unit
HEIDENHAIN
HEIDENHAIN
REF 2 1 SET
= < >
7 8 9
4 5 6
1 2 3
0
.
– CL
MOD
• Clear entry
• Reset to zero (P80!)
• CL plus MOD:
parameter list
• CL plus 2-digit num-
ber: select parameter
• Clear parameter entry
and show parameter
number
Status display • Algebraic
sign
• Decrease
parameter
value
Actual value and input display
(7-segment LED,
9 decades and sign)
Numeric keypad
• Decimal point
• Increase pa-
rameter value
• Output measured value over data
interface (P86!)
• Go to parameter list after switch-on
• Page forward in parameter list
• Select datum
• Page backward in
parameter list
• Confirm entry value
• Set display to value from
P79 (P80!)
Indicator Meaning
REF If decimal points are blinking:
Display is waiting for the reference mark to be crossed over.
If decimal points are not blinking: Reference mark was crossed
over — datum points are now stored in nonvolatile memory.
Blinking: Waiting for operator to press ENT or CL.
1 / 2 Datum 1 / Datum 2 currently active.
SET Blinking: Waiting for operator to confirm entry values.
< / = / > Sorting mode: Measured value less than lower limit /
within tolerance / greater than upper limit.
ND 261