HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 128)

01.98
TNC 407/TNC 415/TNC 425 1 Machine axes 4-3
6.3 Graphics window 4-132
6.3.1 View in three planes 4-132
6.3.2 Rotating the coordinate system 4-132
6.3.3 BLK form and datum shift 4-132
6.4 Status-window 4-134
6.4.1 Position display 4-134
6.4.2 Position display with rotary axes 4-135
6.4.3 Feed rate display 4-138
6.4.4 Display of the M-functions 4-139
6.4.5 Control is in operation 4-140
6.4.6 Cancel status-display 4-140
6.5 PLC-Window 4-141
6.6 Error messages 4-142
6.7 Cycles 4-144
6.7.1 Cycle inhibit 4-144
6.7.2 Pocket milling 4-145
6.7.3 Milling-cycles for pockets with free-programmed contours 4-146
6.7.4 Scaling factor 4-147
6.7.5 Cylinder interpolation 4-147
6.8 Return to the contour 4-148
6.9 Files 4-150
6.9.1 File types – disable and protect 4-150
6.9.2 Block numbers - step size for ISO programs 4-151
6.9.3 Table size 4-151
6.9.4 Datum point for values in datum table 4-151
6.10 User-parameters 4-152
6.11 Code-numbers 4-152
6.12 Programming station 4-153
6.13 Dialogue language 4-153
6.13.1 Decimal sign 4-154
6.14 Memory test 4-154
6.15 End of program 4-154
6.16 Overwrite Q-parameters 4-154
6.17 Arc end-point tolerance 4-155
6.18 Radius compensation R+, R- 4-155
6.19 "POWER INTERRUPTED" Message 4-155
6.20 Help files 4-156