7 cycles, 1 cycle inhibit – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 269

6.7 Cycles
The HEIDENHAIN contouring controls permit calling HEIDENHAIN standard-cycles within the NC
program (e.g.. pecking, tapping, pocket milling etc.). In addition, the manufacturer of the machine
can program manufacturer-cycles and store them in the control (see "OEM-cycles"). The sequence of
some cycles can be altered by machine parameters and PLC-markers. The description of the
"Tapping" and "Spindle-orientation" cycles can be found in the section "Main spindle".
6.7.1 Cycle inhibit
Machine parameter MP7245 can be used to selectively inhibit the HEIDENHAIN standard-cycles.
MP7245.0
Inhibit the HEIDENHAIN Cycles 1 to 15
Entry:
0 to 65 535
$0 to $FFFF
Bit 1
Cycle 1
0 = do not disable
Bit 2
Cycle 2
1 = disable
Bit 3
Cycle 3
Bit 4
Cycle 4
Bit 5
Cycle 5
Bit 6
Cycle 6
Bit 7
Cycle 7
Bit 8
Cycle 8
Bit 9
Cycle 9
Bit 10
Cycle 10
Bit 11
Cycle 11
Bit 12
Cycle 12
Bit 13
Cycle 13
Bit 14
Cycle 14
Bit 15
Cycle 15