HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 444)

5-42
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
Machine
parameter Function and input Change
via Reaction Page
Bit 4 Position after machining
0 =
Return to position that was
approached before cycle was called
1 =
TNC moves tool to clearance height
MP7430 Overlap-factor for pocket milling
Entry: 0.1 to 1.414 PLC RUN
CN 123 4-145
MP7431 Arc end-point tolerance
Entry: 0.0001 to 0.016 [mm] PLC RUN
CN 123 4-155
MP7440 Output of M-functions
Entry: %xxxxx
Bit 0 Program-halt on M06
0 =
Program halt on M06
1 = No program-halt on M06
Bit 1 modal cycle-call M89
0 =
normal code-transfer of M89
at beginning of block
1 = modal cycle-call M89 at end of
block
Bit 2 Program-halt on M-functions
0 =
Program-halt until acknowledgement
of M-function
1 = No program-halt (does not wait for
acknowledgement)
Bit 3 Select Kv factors with M105/M106
0 = function not active
1 = function active
Bit 4 Reduced feed-rate in tool axis with M103
0 = function not active
1 = function active
PLC RUN
CN 123 4-162