beautypg.com

HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual

Page 750

background image


13-10

TNC 407/TNC 415

Subject Index

01.98

Q

Q parameters.............................................. 9-4
Q-Parameters .............. 2-4; 4-140; 4-154; 7-21

R

R (RESET) ............................................... 7-49
Radial acceleration .................................... 4-80
Ramp slope............................................. 4-114
Ramp slope for spindle ............................. 4-97
Range (Module 9010/9011/9012 ............ 7-137
Range cycle ............................................ 4-182
Rapid traverse...................... 2-15; 4-70; 4-174;

.......................................... 4-177; 4-178; 4-191

Read in Word .......................................... 7-137
Re-approaching the contour........... 2-14; 4-148
Reduced feed-rate of tool axis................ 4-161
Reference end-position............................. 4-53
Reference mark ............................... 4-36; 4-62
Reference marks ............................... 4-7; 4-52
Reference marks, traversing .................... 2-15
Reference point ........................................ 4-16
Reference pulse inhibit ............................. 3-35
Releases ................................................... 2-14
REMAINDER (MOD)............................... 7-70
REMAINDER [ ] (MOD[ ])........................ 7-86
REPEAT ... UNTIL Structure ................... 7-128
REPLY..................................................... 7-123
RESET (R) ............................................... 7-49
RESET NOT (RN) .................................... 7-51
Resolution of input and display........ 2-3; 4-134
Resolution, input and display step ............ 2-14
RESTORE......................................... 2-13; 2-18
RESTORE AT N....................................... 4-148
RESTORE POSITION ................... 4-148; 4-149
Reversal errors.......................................... 4-24
Reversal spikes, compensation for......... 11-11
Right-hand rule.......................................... 4-12
Rigid tapping ......................... 2-14; 2-17; 4-117
RM = Reference mark ............................ 4-127
RN (RESET NOT) .................................... 7-51
ROT........................................................... 2-15
Rotary axis ................................................ 4-12
Rotary encoder and ballscrew .................... 4-6
Rotation, non-controlled............................ 2-15
Rounding-arc insertion .............................. 4-82
RPLY (REPLY) ....................................... 7-124
RS-232-C/V.24.................................. 3-40; 8-10
RS-422/V.11 ............................ 3-40; 3-41; 8-15