beautypg.com

Mp1940, Mp1940.0, X axis – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual

Page 723: Mp1940.1, Y axis, Mp1940.2, Z axis, Mp1940.3, 4th axis, Mp1940.4

background image


01.98

TNC 407/TNC 415/TNC 425

3 Machine interfacing

11-9

MP1910

Monitor speed controller (drive monitoring)
Entry: 1 to 16 777 215 [counting steps]

MP1910.0

X axis

MP1910.1

Y axis

MP1910.2

Z axis

MP1910.3

4th axis

MP1910.4

5th axis

The entry is axis-specific and made in counting steps. MP1910.x monitors the theoretically
calculated output voltage of the speed controller. If this voltage exceeds the limit specified in
MP1910.x the error message "Gross positioning error 3F" appears. This voltage is always limited
to ± 10 V at the output.

The input value for MP1910.x can therefore be calculated as follows:

MP 1910.x =

Ulimit

MP1920.x * 9.7 µV

The speed controller integrated in the control system is a PI controller. The P and I components of
the speed controller can be set in machine parameters MP1920.x and MP1940.x.

MP1920

Integral component for speed controller (I component)
Entry: 0 to 65 535
Recommended input range: 50 to 100

MP1920.0

X axis

MP1920.1

Y axis

MP1920.2

Z axis

MP1920.3

4th axis

MP1920.4

5th axis

MP1925

Limiting the integral component for speed controller
Entry: 0.000 to 65.535 [s]
Recommended input range: 0.1 to 2 s

MP1925.0

X axis

MP1925.1

Y axis

MP1925.2

Z axis

MP1925.3

4th axis

MP1925.4

5th axis

MP1940

Proportional component for speed controller (P component)
Entry: 0 to 65 535
Recommended input range: 50 to 200

MP1940.0

X axis

MP1940.1

Y axis

MP1940.2

Z axis

MP1940.3

4th axis

MP1940.4

5th axis