HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 466)

01.98
TNC 407/TNC 415/TNC 425 7-5
4.7 Files 7-157
4.7.1 Executing a Pallet Program (Module 9090) 7-157
4.7.2 Tool and Datum Table (Module 9092/9093/9094) 7-158
4.7.3 Non-linear Axis Error Compensation (Module 9095) 7-161
4.8 Data Interface 7-162
4.8.1 Assign Data Interface (Module 9100) 7-163
4.8.2 Enable Data Interface (Module 9101) 7-163
4.8.3 Status of Data Interface (Module 9102) 7-164
4.8.4 Transmit String across Data Interface (Module 9103) 7-165
4.8.5 Receive String across Data Interface (Module 9104) 7-165
4.8.6 Transmit Binary Data across Data Interface (Module 9105) 7-167
4.8.7 Receive Binary Data across Data Interface (Module 9106) 7-167
4.8.8 Read from Receive Buffer (Module 9107) 7-168
4.8.9 Transmit a Message by LSV/2 (Module 9110) 7-169
4.8.10 Read a Message by LSV/2 (Module 9111) 7-170
4.9 PLC Axes 7-171
4.9.1 Start PLC Axis (Module 9120) 7-171
4.9.2 Stop PLC Axis (Module 9121) 7-172
4.9.3 Status PLC Axis (Module 9122) 7-172
4.9.4 Traverse Reference Marks for PLC Axis (Module 9123) 7-173
4.9.5 Override for PLC-axis (Module 9124) 77 7-174
4.10 Analogue voltage output (Module 9130) 7-176
4.11 Inserting an NC block (Module 9150) 7-177
4.12 Spindle orientation (Module 9171) 7-178
5 Compatibility with TNC 355 7-179
5.1 PLC Program Conversion 7-180
5.2 Compatibility Markers 7-181
5.3 Incompatibility 7-183
5.3.1 PLC Macros 7-183
5.3.2 PLC Error Messages 7-185
5.3.3 Mode Code 7-185
5.3.4 Non-Implemented Markers 7-186
5.3.5 PLC Cycle Time 7-187