HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 424)

5-22
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
3.6 Spindle
Machine
parameter Function and input Change
via Reaction Page
MP3010 Spindle-speed output, Spindle orientation
Entry: 0 to 8
0 = No spindle-speed output
1 = BCD-coded output of the spindle speed,
only if the spindle speed changes
2 = BCD-coded output of the spindle-speed
at every TOOL CALL
3 = Analogue output of the spindle speed, but
gear-change signal only if the gear range
changes
4 = Analogue output of the spindle speed and
gear-change signal at every TOOL CALL
5 = Analogue output of the spindle speed and
no gear-change signal
6 = As for entry value 3, but with controlled
spindle for orientation
7 = As for entry value 4, but with controlled
spindle for orientation
8 = As for entry value 5, but with controlled
spindle for orientation
PLC EDIT RESET 4-94
MP3011 Function of analogue output S if MP3010 < 3
Entry: 0 to 2
0 = No special function
1 = Voltage proportional to current contour feed
rate (dependent on MP3012)
2 = Voltage as defined by PLC module 9130
3 = Voltage as defined via M function (M200 to
M204)
4-275
MP3012 Feed-rate for output of an analogue voltage of 10 V
(MP3011 = 1)
Entry: 0 to 300 000 [mm/min] 4-207
MP3013.0 to
MP3013.11 Characteristic curve kink points for analogue
voltage output with M202
Entry: 10 to 300 000 [mm/min] 4-277
MP3014.0 to
MP3014.11 Characteristic curve kink points for analogue
voltage output with M202
Entry: 0.000 to 9.999 [V] 4-277
MP3020 Definition of the spindle speed range
Entry: 0 to 99 999 PLC EDIT 4-104