beautypg.com

6 controlled axes, 1 axis-enable, feed rate enable – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual

Page 214

background image


01.98

TNC 407/TNC 415/TNC 425

3 Servo positioning of the NC-axes

4-89

3.6 Controlled axes

The machine parameter MP50 determines which of the five NC-axes should be controlled.

MP50

Controlled axes
Entry: %xxxxx

Bit 0

X axis

0 = not controlled

Bit 1

Y axis

1 = controlled

Bit 2

Z axis

Bit 3

4th axis

Bit 4

5th axis

Further parameters for the NC-axes may be found in the section "machine axes".

The PLC functions which are described in the following sections are only effective for controlled
axes.

3.6.1 Axis-enable, feed rate enable

After switching on the control voltage the "Axis-enable markers" are automatically set by the NC, so
that the machine axes can be held in closed position loops by the control .

The axis-enable markers can be reset by the NC if the control loop is opened by the PLC, see
section "Open control loop").

Marker

Function

Set

Reset

M2000

Axis enable X

NC

NC

M2001

Axis enable Y

M2002

Axis enable Z

M2003

Axis enable 4

M2016

Axis enable 5

The feed rate enable must be specified for all axes by M2451 and complement marker M2467 or
through byte B520 before the axes can be moved. If the feed rate enable is removed, the analogue
voltage is output as 0 V and the axes immediately stop moving. The letter "F" is then highlighted in
the status display.