HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 319

MP6500
Tool Calibration with TT 110
Entry:
0 or 1
0 =
Cycles for tool calibration inhibited
1 =
Cycles for tool calibration not inhibited
MP6505
Probing direction for tool measurement
Entry:
0 to 3
0 =
Positive probing direction in the angle reference axis (0°axis)
1 =
Positive probing direction in the +90°-axis
2 =
Negative probing direction in the angle reference axis (0° axis)
3 =
Negative probing direction in the +90°-axis
MP6507
Calculation of the probing feed rate
Entry:
0 to 2
0 =
Calculation of the probing feed rate with constant tolerance
1 =
Calculation of the probing feed rate with variable tolerance
2 =
Constant probing feed rate
MP6510
Max. permissible measuring error for tool measurement with rotating tool
Entry:
0.002 to 0.999 [mm]
MP6520
Probing feed rate for tool measurement with non-rotating tool
Entry:
10 to 3000 [mm/min]
MP6530
Distance from tool lower edge to probe contract upper edge for tool radius
measurement
Entry:
0.001 to 99.9999 [mm]
MP6531
Diameter or edge length of the TT 110 probe contact
Entry:
0.001 to 99 999.9999 [mm]
MP6540
Safety zone around the probe contact TT 110 for pre-positioning
Entry:
0.001 to 99 999.9999 [mm]
MP6550
Rapid traverse in the probing cycle for TT 110
Entry:
10 to 10 000 [mm/min]
MP6560
Spindle orientation for measuring individual teeth
Entry:
–0 to 88
–1
= Spindle orientation directly via NC
0
= Function inactive (error message)
1 to 88 = Number of the M function for spindle orientation via PLC