beautypg.com

See also the heading "machine control panel, 2 machine-control panel – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual

Page 299

background image


4-174

TNC 407/TNC 415/TNC 425

8 Key-simulation

01.98

8.2 Machine-control panel

A manufacturer's specific machine-control panel can be connected to the HEIDENHAIN contouring
controls. See under "Assembly and electrical installation".

25 PLC inputs (I 128 to I 152) and 8 PLC outputs (O 0 to O 7) are available on the female connector
X46 for the evaluation of the keys on the machine-control panel. The evaluation of the signals from
the machine-control panel must be performed in the PLC-program. The appropriate markers will be
set thereby. For safety reasons a complement-marker must be reset when some functions are
activated. This is especially so for keys with several contacts. If the complement-marker is not
properly set or reset, the flashing error message "Error in PLC-program" will appear. The displayed
code identifies the marker where the error has occurred.

An axis-direction key which has been operated can be stored by marker M2450 (Complement-
marker M2466) . This means that the axis will be traversed until NC STOP occurs. This memory
function must be activated by machine parameter MP7680 Bit 0.

MP7680 - Machine parameter with multiple-function

Bit 0 - Memory function for axis-direction keys

0 = Not stored
1 = Stored

Marker Function

Error

message

Set

Reset

M2448

NC-start (edge evaluation)

1A

PLC

PLC

M2464

Complement NC-start

M2449

Rapid traverse

1B

M2465

Complement - rapid traverse

M2488

NC-stop ("0" signifies stop)

M2450

Memory function for axis-direction keys

1C

M2466

Complement - memory function for
axis-direction keys

M2451

Feed-release

1D

M2467

Complement - feed-release

M2456

Manual traverse X+

1I

M2472

Complement - manual traverse X+

M2457

Manual traverse X-

1J

M2473

Complement - manual traverse X-

M2458

Manual traverse Y+

1K

M2474

Complement - manual traverse Y+

M2459

Manual traverse Y-

1L

M2475

Complement - manual traverse Y-