HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 696)

01.98
TNC 407/TNC 415/TNC 425 5 Error messages 8-49
5.2 HEIDENHAIN peripherals' error codes
These error messages refer to the FE401 floppy disk unit and to magnetic tape unit ME 101/
ME 102. With the floppy disk unit (FE 401) connected, one of the following error codes could be
outputted by the TNC:
Error code Meaning
ERR: 001 Wrong instruction code
ERR: 002 Illegal program name
ERR: 003 Defective data transmission
ERR: 004 Program incomplete
ERR: 010 Program not on floppy disk
ERR: 011 Program protected against erasure
ERR: 012 Program storage in progress
ERR: 013 Program directory full
ERR: 014 Floppy disk full
ERR: 100 Floppy disk not formatted
ERR: 101 Sector number too large
ERR: 102 Drive not ready
ERR: 103 Floppy disk write-protected
ERR: 104 Data on floppy disk defective
ERR: 105 Sectors not found
ERR: 106 Check sum defective
ERR: 107 Disk controller faulty
ERR: 108 DMA faulty
If a magnetic tape unit is connected, the following error codes could be sent to the TNC and an
appropriate error message outputted:
Error code Error message
<1><0> TRANSFERRED DATA INCORRECT
<1><1> DATA CARRIER MISSING
<1><2> DATA CARRIER WRITE-PROTECTED
<1><3> WRONG OPERATING MODE
<1><4> WRONG PROGRAM DATA
<1><5> DATA CARRIER EMPTY
<1><6> PROGRAM INCOMPLETE
<1><7> ME: END OF TAPE
A detailed description of these peripherals can be found in the appropriate operating manual.