HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 646)

01.98
TNC 407/TNC 415/TNC 425 5 Compatibility with TNC 355 7-185
5.3.4 Non-Implemented Markers
Marker Function
M2020 Spindle speed under-ranged
M2021 Nominal/actual speed difference over-ranged
M2024 Touch probe ready
M2049 Mode : Background Programming
M2050 Mode: Programming & Editing
M2056 Mode: Test program
M2060 DIN/ISO Programming
M2062 "Code number" dialog
M2063 Central tool file
M2188 Checksum error for non-volatile Q parameters
M2288 X axis was moving when program aborted
M2289 Y axis was moving when program aborted
M2290 Z axis was moving when program aborted
M2291 Axis 4 was moving when program aborted
M2292 Axis 5 was moving when program aborted
M2504 Axis clamping after constant contour transition
M2509 Activate a % factor for feed rate over-ride
M2510 Deactivate spindle over-ride
M2511 Deactivate feed rate over-ride
M2526 Switch X/Y or Z to 4th axis
M2542 Complement for M2526
M2585 PLC positioning axis S (lsb)
M2586 PLC positioning axis S
M2587 PLC positioning axis S
M2588 PLC positioning axis S
M2589 PLC positioning axis S (msb)
M2590 Define the axis to be switched to 4th axis (lsb)
M2591 Define the axis to be switched to 4th axis (msb)
M2592 Tool number from M2560 to M2567
M2593 Go to Hirth grid after NC STOP
M2594 Central tool file cannot be edited
M2595 Output tool number in addition to pocket number
M2596 Select central tool file during active program run mode
M2598 Transfer tool number
M2599 Transfer tool number
M2602 Define reference point traverse
M2603 Axis sequence for reference point traverse (lsb)
M2604 Axis sequence for reference point traverse
M2605 Axis sequence for reference point traverse
M2606 Axis sequence for reference point traverse
M2607 Axis sequence for reference point traverse (msb)
M2657 Display a second auxiliary function
M2664 No standstill monitoring X axis
M2665 No standstill monitoring Y axis
M2666 No standstill monitoring Z axis