Software, 1 nc-software, Number – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 11: 2 software, Types, 3 software, 1 nc-software 3.1.1 nc-software number, 2 software types

01.98
TNC 407/TNC 415/TNC 425
3 Software
2-7
3 Software
The logic unit contains separate software for the NC section and the PLC section. The software is
identified by an 8-figure number.
After switching on the control, the NC, PLC and Software-Options software numbers are displayed on
the screen. The software number can also be directly requested with the aid of the MOD function.
3.1
NC-Software
3.1.1 NC-Software number
The 8-figure NC software number identifies the type of control, the dialog language (language of the
country) and the version of the software.
Software type
259 96 0 01
National language
Software version
0 = German
1 = Czech
2 = French
3 = Italian
4 = Spanish
6 = Swedish
7 = Danish
8 = Finnish
9 = Dutch
In addition to the above-listed languages, the TNC can always use English, which may be selected via
the machine parameter MP7230.
3.1.2 Software types
Due to restrictions on the export of the TNC 415 B, HEIDENHAIN can also deliver a special export
version. This export version is differentiated from the standard control through the installed software
type. With this software type, the control offers different features in respect of linear interpolation and
the entry/display resolutions.
Linear interpolation
Entry/Display
Resolution
TNC 415 B (Standard)
5 of 5 axes
up to 0.1
µ
m
TNC 415 F (Export)
4 of 5 axes
up to 1
µ
m
The TNC 407 does not fall under the export restrictions, therefore no export version is necessary.