HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 743)

01.98
TNC 407/TNC 415 Subject Index 13-3
C
C ............................................................... 7-26
Cable adapters.......................................... 3-81
Cable overview ......................................... 3-72
Calibrating............................................... 4-178
Call Module (CM).................................. 7-107
CALL-active ................................................ 9-3
CAN (CANCEL) ..................................... 7-124
Cancel status-display .............................. 4-140
Cancellable error message ..................... 4-120
Cascade control ........................................ 4-65
CASE (CASE OF) .................................. 7-129
CASE Branch .......................................... 7-129
Centre offset .......................................... 4-178
Change direction of spindle rotation......... 4-96
Character frame.......................................... 8-6
CM (CALL MODULE) ........................... 7-107
CMF (CALL MODULE IF FALSE) ......... 7-108
CMT (CALL MODULE IF TRUE) ............ 7-107
CN 123........................................................ 5-4
Code for M-function ............................... 4-159
Code length ................................................ 7-7
Code number............ 2-15; 4-31; 4-77; 5-4; 7-6
Code numbers ........................................ 4-258
Coded output, BCD ................................ 4-104
Code-numbers ........................................ 4-152
Colour adjustment .................................. 4-130
Command ................................................. 7-16
Commands ............................................... 7-36
Comment.................................................... 5-3
Comments.................................................. 7-6
Commissioning....................................... 4-258
Comparisons............................................. 7-73
Compensation Assignment ...................... 8-18
Compensation of reversal spikes ............. 2-14
Compensation table.................................. 8-18
Compensation value table ............... 2-20; 4-27
COMPILE.................................................. 7-12
Complement............................................. 7-38
Complement marker............................... 4-209
Connection box......................................... 3-32
Connections, summary of ........................ 3-14
Connector assignment X10 ...................... 3-35
Connector assignment X12 ...................... 3-36
Connector assignment X8 ........................ 3-32
Connector assignments
X1, X2, X3, X4, X5..................................... 3-25
Connector assignments X6, X7 ................ 3-26
Constant ................................................... 7-18
Constant feed rate.................................... 4-80
Constants Field (KF)................................ 7-127
Contour behaviour .................................... 4-80
Contour interpolation ................................ 11-2
Contour lines cycle ...................... 4-180; 4-182
Contour train ............................................. 2-18
Control and signal lines............................. 8-11
CONTROL OPERATIONAL
- PLC I/O ports ........................................ 4-120
Controlled ................................................. 4-89
Cooling........................................................ 3-9
Coordinate system.................................. 4-221
Coordinates, read.................................... 7-145
Copy in Marker ....................................... 7-136
Correction table ........................................ 4-28
Correction value...................................... 4-221
Count direction for handwheel ............... 4-197
Count direction for spindle........................ 4-96
Counter ............................................ 7-18; 7-26
Counting direction............................ 4-8; 4-189
Counting step ............................................. 4-7
Current tool axis........................................ 4-14
Cutting machines.................................... 4-275
Cycle 14 ...................................................... 9-2
Cycle 17 .................................................. 4-117
Cycle 18 .................................................. 4-118
Cycle inhibit ............................................ 4-144
Cycles ..................................................... 4-144
Cylinder interpolation ................................ 4-41
Cylinder surface ............................. 2-20; 4-147