HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 274)

01.98
TNC 407/TNC 415/TNC 425 6 Display and operation 4-149
MP7680 Machine parameter with multiple function
Entry: %xxxxxxx
Bit 1 Return to the contour 0 = inactive
1 = active
Bit 2 Block scan 0 = inactive
1 = active
Bit 3 Interruption in block scan on STOP 0 = interruption
or M06 1 = no interruption
Bit4 Allow for the programmed 0 = allow for dwell time
dwell time during block scan 1 = ignore dwell time
Bit 5 Start calculation for block scan 0 = Start from cursor
1 = Start from program start
MP951 Simulated tool change position for TOOL CALL during block scan
Entry:
−
99 999.9999 to +99 999.9999
[
mm
]
or
[°]
MP951.0 Axis X
MP951.1 Axis Y
MP951.2 Axis Z
MP951.3 4th axis
MP951.4 5th axis
MP7450 Calculate the tool change position from MP951 in block scan
Entry: %xxxxx
Bit 0 Axis X 0 = Calculate
Bit 1 Axis Y 1 = Do not calculate
Bit 2 Axis Z
Bit 3 4th axis
Bit 4 5th axis
Marker Function Set Reset
M2018 Soft key "Manual operation" pressed NC NC
M2019 "Restore position" is active NC NC
M2612 No change in position number PLC PLC
in central tool memory
M2059 Block scan is active NC; PLC NC; PLC