HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 127

4-2
TNC 407/TNC 415/TNC 425
1 Machine axes
01.98
3.3.3 Offset adjustment with integral factor
3.4.2 Constant feed rate in corners
3.4.3 Constant feed rate in corners with M90
3.4.4 Contour speed related to tool cutting edge
3.4.5 Preset tolerance at corners
3.5.1 Position monitoring for operation with lag
3.5.2 Position monitoring for operation with feed precontrol
3.5.3 Monitoring the analogue voltage
3.6.1 Axis-enable, feed rate enable
3.6.5 Actual - nominal value transfer
4.1 Analogue output of the spindle speed
4.1.1 Direction of spindle rotation
4.2 BCD-coded output of spindle speed
4.4.1 Tapping with floating tap holder for analogue spindle-speed output
4.4.2 Tapping with floating tap holder and BCD-coded spindle-speed output
This manual is related to the following products: