HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 130

01.98
TNC 407/TNC 415/TNC 425
1 Machine axes
4-5
15.1.2 Tool life, replacement tool
15.2 Controlling the tool changer
15.2.1 Output of tool number (fixed pocket coding)
15.2.2 Output of pocket number (variable pocket coding)
15.3.1 Program module TOOL DEF
15.3.2 Program module TOOL CALL
15.3.4 Program module STANDBY BACK
15.3.5 Program module MANUAL TOOL IN
15.3.6 Program module MANUAL TOOL OUT
15.3.7 Program module MANUAL TOOL IN/OUT
15.3.9 Program module COMPARE P-CODE WITH ISTREG
15.3.10 Program module COMPARE GRE1 WITH ISTREG
15.3.11 Program module COMPUTE SHORTEST PATH
16 Commissioning and start-up procedure
16.1 Code numbers for commissioning
16.2 Preparation of the machine
16.3 Commissioning the control
16.3.1 Entry of the provisional and pre-defined machine parameters
16.3.2 Entry of the PLC-program
16.3.3 Testing the EMERGENCY STOP routine
16.3.4 Testing the direction of traverse
16.3.5 Fixing the software limit switch ranges
16.3.6 Optimizing the control with lag (MP1390 = 1)
16.3.7 Optimizing the control with feed pre-control (MP1390 = 0)
16.3.8 Optimize the integral factor
16.3.10 Adjustment of the monitoring functions
17 Special functions for laser cutting machines
17.1.1 Voltage proportional to feed rate (MP3011 = 1)
17.1.2 Voltage from the PLC (MP3011 = 2)
17.1.3 Definition of the voltage via M function (MP3011 = 3)
17.2 Graphic simulation without TOOL CALL