12 machining and program run, 7400 to 7599, Machining and program run – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 443

3.12 Machining and program run
Machine
parameter
Function and input
Change
via
Reaction
Page
”Scaling factor” cycle in two or three axes
Entry: 0 or 1
Tool data in touch probe block
Entry: 0 or 1
0 = With the touch probe block the current tool
data are overwritten with the calibrated data
of the probe system.
1 = The current tool data are retained even with
Cycles for milling pockets with free-programmed
contours
Entry: %xxxx
Anti-clockwise slot-milling of the
pocket contours, clockwise for
islands
Clockwise slot-milling of the pocket
contours, anti clockwise for islands
Sequence for clearing out and slot milling
0 =
First slot-milling, then clear out
First clear out pocket, then
slot-milling
Contours merged only if the tool
centre paths intersect
Contours merged if the
programmed contours overlap
Clear out and slot-milling to pocket depth,
or for each peck
0 =
Clearing out and slot-milling
performed in one operation for all
pecks