HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 446)

5-44
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
Machine
parameter Function and input Change
via Reaction Page
MP7480.1 Output of tool number or pocket number with
TOOL DEF block
Entry: 0 to 4
0 = No output
1 = Output of tool number only when tool number
changes (W262)
2 = Output of tool number with every TOOL DEF
block (W262)
3 = Output of pocket number (W262) and tool
number (W264) only when tool number
changes
4 = Output of pocket number (W262) and tool
number (W264) with every TOOL DEF block
PLC RUN 4-229
MP7490 Number of traverse ranges
Entry: 0 to 3
0 = 1 traverse range, 3 datum points
1 = 3 traverse ranges, 3 datum points
2 = 1 traverse range, 1 datum point
3 = 3 traverse ranges, 1 datum point
PLC RUN 4-17
MP7500 MP7500 "Tilt working plane" function
Entry: 0 or 1
0 = inactive
1 = active
PLC EDIT 4-42
MP75x0 MP75x0 Transformed axis
Entry: %xxxxxx
Entry 0 means "End of transformation sequence"
Bit 0 X axis
Bit 1 Y axis
Bit 2 Z axis
Bit 3 A axis
Bit 4 B axis
Bit 5 C axis
PLC EDIT 4-42