HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 450)

01.98
TNC 407/TNC 415/TNC 425 61 List of markers 6-1
6 1 List of markers
The markers listed in italics have been retained to ensure compatibility with the TNC 355. It is
recommended, however, that these functions be activated through the new word functions.
Marker Function Set Reset Page
M2000 Axis enable X NC NC 4-89
M2001 Axis enable Y NC NC 4-89
M2002 Axis enable Z NC NC 4-89
M2003 Axis enable 4 NC NC 4-89
M2004 S-analogue voltage not on a ramp NC NC 4-97
M2005 S-analogue voltage = 0 V NC NC 4-97
M2007 Spindle in position NC NC 4-108
M2008 X axis in position NC NC 4-90
M2009 Y axis in position NC NC 4-90
M2010 Z axis in position NC NC 4-90
M2011 4th axis in position NC NC 4-90
M2012 Lubrication pulse X axis, since value of MP4060.0
was exceeded NC NC 4-20
M2013 Lubrication pulse Y axis, since value of MP4060.1
was exceeded NC NC 4-20
M2014 Lubrication pulse Z axis, since value of MP4060.2
was exceeded NC NC 4-20
M2015 Lubrication pulse 4th axis, since value of MP4060.3
was exceeded NC NC 4-20
M2016 Axis enable 5 NC PLC 4-89
M2017 Axis 5 in position NC NC 4-90
M2018 Soft key ”Manual operation” pressed NC NC 4-148
M2019 ”Restore position” is active NC NC 4-148
M2022 Touch probe system not ready (ready-signal missing on
connector X12 or signals from TM are faulty) NC NC 4-178
M2023 Stylus deflected before start of probing cycle NC NC 4-178
M2025 Stylus deflected (probe operation has been performed) NC PLC 4-178
M2026 Probe operation ended or interrupted NC NC 4-178
M2027 Battery voltage too low (battery-warning on connector X12);
is evaluated only during the probe operation NC NC 4-178
M2029 Lubrication pulse 5 axis, since value of MP4060.4
was exceeded NC NC 4-20
M2032 T-Code 1st bit (lsb) NC NC 7-177
M2033 T-Code 2nd bit NC NC 7-177
M2034 T-Code 3rd bit NC NC 7-155
M2035 T-Code 4th bit NC NC 7-155
M2036 T-Code 5th bit NC NC 7-155
M2037 T-Code 6th bit NC NC 7-155
M2038 T-Code 7th bit NC NC 7-155
M2039 T-Code 8th bit (msb) NC NC 7-155
M2041 Basic language – English is selected NC NC 4-153
M2042 Analogue output of the spindle speed NC NC 4-95
M2043 Gear code change signal NC NC 4-101
M2044 S-code change signal NC NC 4-104