2 protocols – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 677

Example of software handshake:
Peripheral unit
Transmission path
Receive buffer fulll
Receive butter
ready again
12 Z+Z FMAX
13 Z–10 F100 M03
TNC
.
.
.
.
.
.
Hardware handshake (see section "Freely configurable interfaces")
3.1.2 Protocols
This section lists the transfer protocols for the various methods of data output and input.
The EXT1 mode is set:
– Control character for "End of Text":
– Control character for "End of Transfer":
– Software handshake
This manual is related to the following products: