beautypg.com

2 current tool axis, 3 vdu display – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual

Page 139

background image


4-14

TNC 407/TNC 415/TNC 425

1 Machine axes

01.98

MP120

Assignment of the analogue outputs

Entry:

0 = output 1
1 = output 2
2 = output 3
3 = output 4
4 = output 5
5 = output S

MP120.0

X axis

MP120.1

Y axis

MP120.2

Z axis

MP120.3

4th axis

MP120.4

5th axis

1.2.2 Current tool axis

In the NC-block "TOOL CALL" it is determined whether the tool moves parallel to one of the principal
axes X, Y, Z or parallel to the fourth axis. The fifth axis may not be defined as a tool axis. The
markers M2100 to M2103 are used to show which of the four axes is currently defined as the tool
axis. The appropriate marker is then set.

Marker

Function

Set

Reset

M2100

X-axis is tool axis

NC

NC

M2101

Y-axis is tool axis

M2102

Z-axis is tool axis

M2103

4th axis is tool axis

1.3 VDU display

Machine parameters can be used to select which of the active axes (MP10) should be displayed in
the status window.
The spindle position is displayed only when neither M03 nor M04 is active (see under "Main
spindle").

MP40 VDU

display

Entry: %xxxxx

Bit 0

X axis

0 = not active

Bit 1

Y axis

1 = active

Bit 2

Z axis

Bit 3

4th axis

Bit 4

5th axis

Bit 5

Axis S