1 assignment – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 138
A secondary linear axis is designated by the letter U, V or W. The correlation with the principal
axes and the direction of travel are also standardized in ISO 841.
+Y
+X
+U
+V
+W
+Z
MP410
Axis designation
Entry:
0 = A
1 = B
2 = C
3 = U
4 = V
5 = W
MP410.3
4th
axis
MP410.4
5th axis
1.2.1 Assignment
The measuring system inputs X1 to X6 and the analogue outputs, Output 1 to Output S (on the
connector X8 ) can be assigned to the individual axes. The assignment is determined by the machine
parameters MP110 and MP120.
The assignment of measuring system input X6 and the nominal value output S to one of the five
axes is only possible when the function Spindle-Orientation is not utilised.
MP110
Assignment of the measuring system inputs to the axes
Entry:
0 = measuring system input X1
1 = measuring system, encoder input X2
2 = measuring system, encoder input X3
3 = measuring system, encoder input X4
4 = measuring system, encoder input X5
5 = measuring system, encoder input X6
MP110.0
X axis
MP110.1
Y axis
MP110.2
Z axis
MP110.3
4th axis
MP110.4
5th axis