HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 418)

5-16
TNC 407/TNC 415/TNC 425 3 List of machine parameters 01.98
Machine
parameter Function and input Change
via Reaction Page
MP1331 Feed rate for leaving the reference end-position
(only for rotary encoders MP1350 = 2)
Entry: 80 to 500 [mm/min]
MP1331.0
X axis
MP1331.1 Y axis
MP1331.2 Z axis
MP1331.3 4th axis
MP1331.4 5th axis
PLC RUN 4-62
MP1340 Sequence for traversing reference marks
Entry: 0 = no evaluation of reference mark
1 = X axis
2 = Y axis
3 = Z axis
4 = 4th axis
5 = 5th axis
MP1340.0 1st axis
MP1340.1 2nd axis
MP1340.2 3rd axis
MP1340.3 4th axis
MP1340.4 5th axis
PLC RUN REF 4-62
MP1350 Type of reference mark approach
Entry:
0 = measuring system with distance-coded
reference marks
1 = measuring system with one reference mark
2 = special sequence (linear measurement by
rotary encoder)
3 = measuring system with distance-coded
reference marks
MP1350.0 X axis
MP1350.1 Y axis
MP1350.2 Z axis
MP1350.3 4th axis
MP1350.4 5th axis
PLC EDIT REF 4-53
MP1390 Feed precontrol in the "Positioning with manual
data input", "Program run, single block" and
"Program run, full sequence" modes
Entry: 0 or 1
0 = operation with feed precontrol
1 = operation with lag PLC EDIT 4-75
MP1391 Feed precontrol in the "Manual" and "Handwheel"
modes
Entry: %xxxxx
0 =
operation with lag
1 = operation with feed precontrol
Bit 0 X axis Bit 3 4th axis
Bit 1 Y axis Bit 4 5th axis
Bit 2 Z axis
PLC EDIT 4-33
4-75