HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 456

Marker
Function
Set
Reset
Page
Reset of accumulated distance for lubrication Y axis
Reset of accumulated distance for lubrication Z axis
Reset of accumulated distance for lubrication of axis 4
Actual – nominal value transfer X axis
Actual – nominal value transfer Y axis
Actual – nominal value transfer Z axis
Actual – nominal value transfer 4 axis
Reference end-position for X axis
Reference end-position for Y axis
Reference end-position for Z axis
Reference end-position for axis 4
BCD numerical values for PLC positioning, tool number, spindle
orientation and Q parameters
Tool number: output mode
0 = binary 1 = BCD
Tool change sequence for changing from special tools to
normal tool
Return special tool to its original pocket in spite of flexible
pocket coding
Status-display M03, M04, M05 inverse and S-analogue output
= 0V
Status-display M08, M09 inverse
M2610
T-character for tool status is displayed inverted
PLC
PLC
—
Confirm the transfer with FN19
Do not update pocket number in pocket table
Reset of accumulated distance for lubrication axis 5
M2614
Read-in inhibited (after acknowledgement of the M/S/T/Q
strobes the subsequent NC blocks are not executed)
PLC
PLC
—
Repeat reference mark evaluation for spindle-orientation
Spindle-orientation from stop
0 = Orientation with M03
1 = Orientation with M04