12 programming station, 13 dialogue language – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 278

The value of the code-number which is entered is stored in Doubleword D276. The machine
manufacturer can evaluate this code with the aid of the PLC and define his own functions for code
numbers or disable the preset code numbers.
Address
Function
D276
Value of the code-number most recently entered by MOD
6.12 Programming station
Machine parameters can be used to set the control so that it can be utilized as a programming
station, without the machine. In this setting only the operating modes "Programming and editing"
and "Program test" function. It is possible to select whether the PLC should be active or not in the
"programming station" setting.
MP7210
Programming station
Entry values: 0, 1, 2
Entry:
0 = Control and programming
1 = Programming station, "PLC active"
2 = Programming station, "PLC inactive"
6.13 Dialogue language
The HEIDENHAIN contouring controls are available in ten different dialogue languages, see chapter
"Introduction". The dialogue language can be altered by a simple software exchange. English, as a
basic language, is stored in every control as a second language and can be selected by machine
parameter.
If the basic language English has been selected, then marker M2041 is set by the NC.
MP7230
Change dialogue language
Entry: 0 or 1
0 = First dialogue language
1 = Basic language - English
Marker
Function
Set
Reset
M 2041
Basic language - English is selected
NC
NC