HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 639)

7-178
TNC 407/TNC 415/TNC 425 5 Compatibility with TNC 355 01.98
5 Compatibility with TNC 355
The marker ranges for the TNC 355 have also been used for the TNC 407 and TNC 415 to enable
PLC routines created for the TNC 355 to be run on the TNC 407 and TNC 415 as well.
However there are many functions that can be programmed much more simply with PLC words
with the TNC 407 and TNC 415. PLC marker M2719 must be set to activate the strobes for word
processing.
Marker Function Set Reset
M2719 Deactivate the TNC 355 modules PLC PLC
0 = Activate strobes for marker range
1 = Activate strobes for word processing
M2719 = 1 M2719 = 0
Meaning Marker Data Marker Data
Start PLC-Pos. X 2704 D528 2452 M2560 to M2564
Start PLC-Pos. Y 2705 D532 2453 M2565 to M2569
Start PLC-Pos. Z 2706 D536 2454 M2570 to M2574
Start PLC-Pos. IV 2707 D540 2455 M2575 to M2579
Read out strobe for
values in Q
parameter (Q100
to Q107) 2713 D528 2809 M2560 to M2576
Read out strobe
tool number -- 1) −
2599 M2560 to M2567
M2112 to M2119
Read in strobe tool
number
− 1) −
2598 M2560 to M2567
M2572 to M2579
Strobe datum
correction 2716 D528 to D540 2819 MP4210.32 to
MP4210.46
Spindle orientation 2712 D592 2527 M2585 to M2589
HEIDENHAIN recommend programming the PLC functions over the word range only. This makes
the PLC program easy to read and a lot shorter.
1) Module 9093/9094