HEIDENHAIN ND 287 User Manual User Manual
Nd 287
This manual is related to the following products:
Table of contents
Document Outline
- Introduction
- Working with the ND 287 position display unit
- I – 1 ND 287 position display unit
- I – 2 Fundamentals of positioning
- I – 3 Basic functions of the ND 287
- I – 4 Job Setup
- I – 5 Series of measurements and statistical process control
- Functions
- Switching between series of measurements and SPC mode
- Calling the SERIES OF MEASUREMENTS menu
- Analysis of series of measurements
- Setting up a series of measurements
- Defining the display for a series of measurements
- Setting the position or speed display
- Defining the record mode
- Starting and stopping a series of measurements
- Calling the SPC menu
- SPC analysis
- Setting up SPC
- Deleting SPC statistics
- Starting and stopping SPC
- I – 6 Sorting and tolerance checking
- I – 7 Error messages
- Installation, specifications
- II – 1 Installation and electrical connection
- II – 2 Installation Setup
- II – 3 Switching inputs and outputs
- II – 4 Encoder parameters
- II – 5 Data interface
- II – 6 Measured value output
- II – 7 Input and output of parameter list and error compensation table
- II – 8 Specifications for
- II – 9 Dimensions
- II – 10 Accessories