HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 417)

01.98
TNC 407/TNC 415/TNC 425 3 List of machine parameters 5-15
Machine
parameter Function and input Change
via Reaction Page
MP1080 Integral factor
Entry: 0 to 65 535
MP1080.0 integral factor X axis
MP1080.1 integral factor Y axis
MP1080.2 integral factor Z axis
MP1080.3 integral factor 4th axis
MP1080.4 integral factor 5th axis
PLC RUN 4-78
MP1110 Standstill monitoring
Entry: 0.0010 to 30.0000 [mm]
MP1110.0 X axis
MP1110.1 Y axis
MP1110.2 Z axis
MP1110.3 4th axis
MP1110.4 5th axis
PLC EDIT 4-87
MP1140 Movement monitoring
Entry: 0.030 to 10.000 [V]
MP1140.0 X axis
MP1140.1 Y axis
MP1140.2 Z axis
MP1140.3 4th axis
MP1140.4 5th axis
PLC RUN 4-86
MP1150 Delay time before switching off the residual
voltage on error message "Position error"
Entry: 0 to 65 535 [s] PLC RUN 4-85
MP1220 Automatic cyclical offset adjustment
Entry: 0 to 65 536 [s]
0 = no automatic adjustment
PLC RUN 4-77
MP1320 Direction for traversing the reference marks
Entry: %xxxxx
Bit 0 Axis X 0 = positive
Bit 1 Axis Y 1 = negative
Bit 2 Axis Z
Bit 3 4th axis
Bit 4 5th axis
PLC EDIT 4-62
MP1330 Feed rate for traversing the reference marks
Entry: 80 to 300 000 [mm/min]
MP1330.0 X axis
MP1330.1 Y axis
MP1330.2 Z axis
MP1330.3 4th axis
MP1330.4 5th axis
PLC RUN 4-62