beautypg.com

HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual

Page 354

background image


01.98

TNC 407/TNC 415/TNC 425

15 Tool changer

4-229

MP7480.0

Output tool or pocket number with TOOL CALL block
Entry: 0 to 6

0 =

No output

1 =

Tool number output only when tool number changes (W262)

2 =

Tool number output with every TOOL CALL block (W262)

3 =

Output of pocket number (W262) and tool number (W264) only when tool
number changes

4 =

Output of pocket number (W262) and tool number (W264) with every TOOL
CALL block

5 =

Output of pocket number (W262) and tool number (W264)only when tool
number changes. Pocket table does not change.

6 =

Output of pocket number (W262) and tool number (W264) with every TOOL
CALL block. Pocket table does not change.

MP7480.1

Output tool or pocket number with TOOL DEF block
Entry: 0 to 4

0 =

No output

1 =

Tool number output only when tool number changes (W262)

2 =

Tool number output with every TOOL DEF block (W262)

3 =

Output of pocket number (W262) and tool number (W264) only when tool
number changes

4 =

Output of pocket number (W262) and tool number (W264) with every TOOL
DEF block

Word

Function

W262

Pocket number if MP7480 = 3 , 4, 5 or 6
Tool number if MP7480 = 1 or 2

W264

Tool number if MP7480 = 3, 4, 5 or 6

Marker

Function

Set Reset

M2046

Strobe signal T code (P code) with TOOL CALL

NC

NC

M2047

Strobe signal T code (P code) with TOOL DEF

NC

NC

M2483

Feedback T code (P code) with TOOL CALL

PLC

PLC

M2484

Feedback T code (P code) with TOOL DEF

PLC

PLC

M2400

Tool number 0 programmed

NC

NC

M2717

Geometry of the tool from W264

PLC

NC