HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 25

TNC 415 B/TNC 425:
259 93x 11
TNC 415 F/TNC 425 E:
259 94x 11
This version was supplied from 4/94 only
TNC 407:
243 03x 11
when expressly requested by the customer.
New functions:
−
The PLC module 9036 was expanded. The handwheel assignment can now be switched through
the PLC to any desired axis; the assignment is indicated in the status window by the position of
the handwheel symbol.
–
After activation of Cycle 19 "Working plane" the offset is corrected only in the axis that is moved.
Previously the offset was corrected simultaneously in all axes during execution of the first block.
–
With M112 it is now possible to enter a limit angle A in addition to the tolerance T.
TNC 415 B/TNC 425:
259 93x 12
TNC 415 F/TNC 425 E:
259 94x 12
TNC 407:
243 03x 12
Release 5/94