3 output in binary code – HEIDENHAIN TNC 407 (243 020) Technical Manual User Manual
Page 705

9-8
TNC 407/TNC 415/TNC 425
3 Output in binary code
01.98
3 Output in binary code
If the OEM-cycles have been fully tested and the dialogs have been specified, the two can be output
in binary form for EPROM programming, together with the PLC program and the error messages. It
is possible to output the files located in both the PLC EPROM and the NC program memory in binary
code.
An accurate description of file output via the data interface is given in the "PLC Programming"
Manual.
This manual is related to the following products: