HEIDENHAIN TNC 407 (243 020) Technical Manual - Manual (Page 135)

4-10
TNC 407/TNC 415/TNC 425 1 Machine axes 01.98
MP31 Checking the amplitude of the measuring system signals
Entry: %xxxxxx
Bit 0 X axis 0 = not active
Bit 1 Y axis 1 = active
Bit 2 Z axis
Bit 3 4th axis
Bit 4 5th axis
Bit 5 Axis S
MP32 Checking the edge separation of the measuring system signals
Entry: %xxxxxx
Bit 0 X axis 0 = not active
Bit 1 Y axis 1 = active
Bit 2 Z axis
Bit 3 4th axis
Bit 4 5th axis
Bit 5 S-axis